Rinse aid en
15
, Rinse aid
Ri n s e ai d
The rinse aid ensures stain-free dishes
and clear glasses. Use only rinse aid
for domestic dishwashers. As soon as
the rinse aid refill indicator H lights up
in the control panel, there is still a rinse
aid reserve of 1-2 rinse cycles. Top up
the rinse aid.
Top up the rinse aid as follows:
1. Open dispenser 92; press lug on
the lid (1) and lift (2).
2. Add rinse aid up to the max. mark.
3. Close the lid.
The lid "clicks" into position.
4. Remove overflowed rinse aid with a
cloth.
This prevents excessive frothing
during the next rinse cycle.
Setting amount of rinse aid
You can set the amount of rinse aid that
should be added to a value between
:¯¯ and :¯±. Setting the amount of
rinse aid to be dispensed to :¯ will
give you a very good drying result. The
factory setting is :¯. Do not change
the amount of rinse aid unless there are
streaks or water stains on the utensils.
Set a lower level to avoid streaks. Set a
higher level to avoid water stains.
Here’s how to set the amount of rinse
aid:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until :¯...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the digital display h shows
the factory setting :¯.
4. Press the programme button #
repeatedly until the factory setting
value :¯ appears in the display
window h.
5. Press the programme button 3.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value :¯± the
display jumps back to :¯¯ (Off).
6. Press START button `.
The set value is saved.
PD[
To Next Page
Loading...
Need help?
General
