Installation and connection en
49
Removal
Also observe
the sequence of worksteps here.
1. Disconnect the appliance from the
power supply.
2. Turn off the tap.
3. Undo the waste water and drinking
water connection.
4. Loosen fastening screws for the
furniture parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully
pulling the hose behind.
Transporting
Empty the dishwasher and secure loose
parts.
Drain the appliance according to the
following steps:
1. Turn on water supply.
2. Switch on ON/OFF switch (.
3. Select programme with the highest
temperature.
The estimated programme duration
appears in the display window h.
4. Press START button `.
Programme sequence starts.
5. After about 4 minutes, repeatedly
press the START button ` until
¯:¯³ appears in the display window.
After about 1 minute the display
window will show ¯:¯¯.
6. Switch off ON/OFF switch (.
7. Turn off water supply, disconnect
supply hose and drain water.
Note: Always transport the dishwasher
upright. This prevents residual water
from getting into the machine’s controls
and causing the programme sequence
to malfunction.
Protection against frost
Pr ot ect i on agai nst frost (Empt yi ng the appl i anc e)
If the appliance is in a room where
there is a risk of frost (e.g. holiday
home), empty the appliance completely
(see Transportation).
To Next Page
Loading...
Need help?
General
