Ikra IBKH 52 - Fueling; Starting; Stopping the Engine

Gasoline Oil
1L 25ml
5L 125ml
Dispose of empty mixing-oil canisters only at authorized
disposal locations.
Fueling
Before fueling, clean the ller cap and the area around it
to ensure that no dirt falls into the tank.
Always thoroughly shake the mixture in the canister be-
fore fueling your machine.
In order to reduce the risk of burns or other per-
sonal injury from escaping gas vapor and fumes,
remove the fuel ller cap carefully so as to allow
any pressure build-up in the tank to release slowly.
After fueling, tighten fuel cap as securely as pos-
sible by hand.
Starting / Stopping the Engine
STARTING THE ENGINE
WARNING! The engine must be started in an
area at least 3metres fromwhere you relled
the fuel tank.
Before starting the engine:
- Place the machine rmly on the ground.
- Remove the guard from the cutting unit (if used).
- Make sure the cutting unit is not touching the
ground or any other object.
- Make sure you have a rm footing
- Do not stand or kneel on the drive tube.
• Cold starting
NOTE: A “cold” start of the engine means starting it after
at least 5minutes fromwhen it was switched o󰀨 or after
refuelling.
1 Set the switch (15) to «START».
GB-19
2. Operate the starter, turning lever (8) to «OFF»..
3. Press the primer device button (1) ca. 6 times to
prime the carburettor.
4. Press the safety lever (7), activate the throttle trigger
(6) and hold it in this position using the shutter button
(18 - if provided); then release the safety lever (7).
5. Hold the machine rmly on the ground with one hand
on the power unit, in order not to lose control of the
machine during startup.
IMPORTANT: To prevent distortions, the drive tube must
not be used as a support for the hand or knee during
startup.
6. Pull the starter rope (4) slowly for 10 - 15 cm until you
feel some resistance, then tug it hard a few times until
you hear the engine turn over.