Ikra IBKH 52 - 9. Maintenance; Engine Maintenance Schedule; Pole Chain Saw Maintenance Schedule

GB-38
9 MAINTENANCE
Maintenance Chart
ENGINE
Please note that the following maintenance intervals apply for normal
operating conditions. If your daily working time is longer than normal or
working conditions are di󰀩cult (very dusty work area, etc.), shorten the
specied intervals accordingly.
before starting work after nishing work or daily after eachrefueling stop if necessary
Complete machine Visual inspection (condition,
fuel and other leaks)
x x
Clean x
Control handle Check operation x x
Air lterClean Clean x
Replace by a servicing dealer x
Fuel tank Clean x
Carburetor Check idle adjustment – working
tool must not move
x x
Readjust idle x
Spark plug Readjust electrode gap x
Replace after about 100 operating
hours
Cooling inlets Inspect x
Clean x
Spark arrestor* in mu󰀪err Check x
Have cleaned or replaced 1) x
Accessible screws and nuts (not adjusting
screws)
Retighten x
Safety labels Replace x
POLE CHAIN SAW
Please note that the following maintenance intervals apply for normal operating
conditions only. If your daily working time is longer than normal or cutting
conditions are di󰀩cult (very dusty work area, resin-rich wood,tropical wood
etc.), shorten the specied intervals accordingly.
before starting work after nishing work or daily after eachrefueling stop if necessary
Chain lubrication Check x
Saw chain Check, also check sharpness x x
Check chain tension x x
Sharpen x
Guide bar Check (wear, damage) x
Clean and turn over x
Deburr x
Replace x
Chain sprocket Check x
Replace x
Safety labels Replace x