Need help?Do you have a question about the Ilco Orion ECODRILL 2000 C/E and is the answer not in the manual?
Sections of the manual for consultation.
Common technical terms used in the manual are illustrated.
Instructions for proper installation and use of the machine.
Importance of protecting and consulting the manual.
Compliance with directives and general safety measures including power, start-up, illumination, maintenance.
Details about the machine's protective packaging and transport symbols.
Step-by-step instructions for unpacking the machine.
Instructions for safely lifting and carrying the machine.
Lists the types of keys the ECODRILL 2000 C/E can cut.
Details on movements, spring systems, electromechanical settings, lamp, levers.
Labels and descriptions of the machine's working parts.
Specifications and graphic indicating compulsory use of protective goggles.
Main parts of the electrical and electronic circuit.
Details and codes for tools, keys, adapters, fuses, and Allen keys.
Checking for damage, environmental conditions, and positioning requirements.
Overview of operator controls and levers for the work station.
Steps to install and secure cutting tools and tracer points.
Steps for adjusting the cutter and tracer alignment.
How to adjust the tracer springing using ring nuts.
Explanation of the spring system for Laser (sidewinder) keys.
Steps for regulating the spring system for different key types.
Description of the special key-locking jaws and their replacement.
Safety measures, fitting keys, and preparing for cutting operations.
Detailed steps for cutting dimple, laser, and FICHET keys.
Warnings, lubrication, and safety checks before maintenance.
Procedures for replacing the belt, light bulb, and fuses.
Detailed steps for replacing the main circuit board.
Steps to remove and install the machine's motor.
Procedure for replacing the left-hand clamp jaw and alignment.
Procedure for replacing the right-hand clamp jaw and alignment.
Steps to remove and install the left-hand mobile clamp jaw.
Steps to remove and install the right-hand mobile clamp jaw.
Procedure for replacing the central clamp jaw and alignment.
Steps to render the machine unusable for disposal.
Information on waste disposal classification and WEEE regulations.
Information on requesting service and warranty.
General| Brand | Ilco Orion |
|---|---|
| Model | ECODRILL 2000 C/E |
| Category | Industrial Equipment |
| Language | English |
To Next Page
