23
EN
MAKING COFFEE
1 2 3
Before inserting the E.S.E. pod, slowly
lift the lever as far as it will go in order
to expel the used E.S.E. pod. To ensure
correct hygiene and maintain high
product quality, it is advisable to expel
the E.S.E. pod immediately after the
coffee is delivered.
To insert E.S.E. pods, the lever must be
raised until it stays up on its own.
To expel the E.S.E. pods, the lever
must be fully raised.
It is recommended to use E.S.E. illy pods. The
machine is optimised for extracting coffee from
E.S.E. illy pods.
Wait until buttons
and are illuminat-
ed and unblinking.
Lift the lever and insert the E.S.E. illy pod into
the slot with the logo facing the lever. Check
that the entire pod, with the exception of the
tab, is inserted into the slot.
4 5 6 7
Close the lever completely. Place the cup on the support under the dis-
penser spout.
To dispense an espresso coffee, press the
button. To dispense a long coffee, press the
button. If there is some difficulty in closing it, re-open the lever and close it again.
CAUTION: After delivering 10 successive cups of coffee, wait for at least 2 minutes before preparing another coffee.
The machine is designed for single deliveries with a maximum duration of 75 seconds.
Hint
• To prepare a good cup of espresso coffee, use thick, ready-warmed espresso cups if possible, to prevent the coffee from cooling down too quickly. Espresso cups can be warmed by dispensing hot water
from the dispenser nozzle into the cup.
• Use E.S.E. illy pods for espresso coffee, pressing the button. Use E.S.E. illy pods for long espresso coffee, pressing the button.
To Next Page
Loading...
