24
EN
After making a cup of coffee, the used E.S.E. pod must be expelled as follows:
• Lift the opening/closing lever fully (the E.S.E. pod will fall into the relative container).
CAUTION: in the interests of hygiene, it is advisable to remove the E.S.E. pod at the end of each delivery and dispense a small
amount of water to remove any residue.
The specific E.S.E. pod container can hold up to 9 used E.S.E. pods. Empty this container on a regular basis.
• If you want to make another coffee, fit a new E.S.E. pod and repeat the procedure, otherwise close the lever.
The used E.S.E. pod drawer can hold a maximum of 9 E.S.E. pods, so it is advisable to empty it regularly to prevent the E.S.E. pods from getting stuck.
1
To perform this operation, remove the tray
and separate it from the E.S.E. pod drawer by
pushing it downwards; be aware that there
may be liquid in the tray.
2
Empty the drawer and rinse and dry the
components before replacing them in their
housings.
PROGRAMMING THE COFFEE TEMPERATURE
1 2 3
PLEASE NOTE: The factory-set
temperature can be increased and/
or reduced by 3°C or 6°C.
Turn the machine OFF using the main switch.
With the machine off, press the
button
5 times to access the temperature change
function. The and buttons will begin
to flash.
Press the button to increase the temper-
ature by 3 degrees. Press the button to
decrease the temperature by 3 degrees.
To Next Page
Loading...
