27
EN
DESCALING
Limescale accumulation is a normal result of machine use. The machine has an automatic programme that helps optimise cleaning and removes scale deposits from the interior.
CAUTION: If the descaling procedure is not carried out, scale may cause malfunctions that are not covered by the warranty.
If the dispensing buttons flash in alternation, the machine must be descaled.
PLEASE NOTE:
- Make sure that there are no E.S.E. pods inside the machine.
- If there is a voltage drop or the machine is switched off, the cycle continues from where it was stopped when switched on again.
- Do not lift the lever when descaling or rinsing.
Descaling procedure:
1 2 3
4
Turn the machine OFF using the main switch. Fill the tank with 0.6 lt of fresh water and add
the descaling solution.
Make sure that the descaling solution has fully
dissolved in the water in the tank.
Place a container of at least 0.6 lt under the
dispenser.
Turn the machine off by pressing the
button for 5 seconds. The button flashes.
To Next Page
Loading...
