Imax B6 - Lithium Balance Charging Mode; Cell Connection Diagrams

NiCd Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
LiPo FAST CHG
2.0A 11.1V(3S)
Li3S 2.0A 12.59V
FAS 022:43 00682
INCINC
DECDEC
--
++
Start
Enter
Start
Enter
Batt type
Stop
‘>3 seconds’
Current
voltage
battery
Suppiled
capacity
Charge
current
Charging
time
Number
of
cells
This screen shows the real-time status during charge process. Press
BATT TYPE/STOP key once to stop the charge process.
This function is for balancing the voltage of Lithium-polymer battery cells
while charging. In the balance mode, the battery needs to have a balance
lead to connect to the individual port at the right side of the charger. And
you need to connect the battery's output plug to the output of charger.
Charging in this mode is different from the normal modes, because the
built-in processor monitors voltage of individual cell and control input
current fed into each cell to normalize the voltage.
The value on the left side of the
second lines sets the charge
current. The value on the right
side of the second lines sets the
battery pack's voltage. After
setting current and voltage,
press STAR/ENTER for more
than 3 seconds to start the
process.
This displays the number of cells
you set up and the processor
detects. “R” shows the number of
cells detected by the charger and
“S” is the number of cells set by
you at the previous screen. If
both numbers are identical you
can start charging by press
START/ENTER button. If not,
press BATT TYPE/STOP button
to go back to previous screen to
carefully check the number of
cells of the battery pack before
going ahead.
This screen shows the real-time
status during charge process.
Press BATT TYPE/STOP key
once to stop the charge process.
Charging lithium battery in the balance mode
R:3SER S:3SER
CONFIRM(ENTER)
+
+
LiPo 6S
-
+
-
+
-
+
-
+
LiPo 5S
+
3S
-
+
Individual
bal.port
Individual
bal.port
LiPo 4S
-
1cell
2cell
3cell
4cell
5cell
6cell
1cell
2cell
3cell
4cell
5cell
6cell
+ +
2S
LiPo 3S
+
-
- -
LiPo 2S
-
+
1S
Top View
Top View
+
-
LiPo 1S
-
-
Individual Cell Connection Diagram (pin-assignment of 8-pin)