Battery
type
DEC
NiCd Sensitivity
D.Peak Default
NIMH CHARGE Aut
CUR LIMIT 5.0A
NIMH 2.0A 7.42V
CHG 022:45 00890
-
Batt type
Stop
Elapsed
time
INC
+
Charge
current
Battery
voltage
DEC
Start
Enter
-
‘>3 seconds’
INC
+
Charged
capacity
This program is for charging
and discharging of NiCd/NiMH
batteries associated with R/C
models applications. You can
press START/ENTER key to
make it blink and then INC or
DEC to change the parameter
value. Press START/ENTER
key to store the value.
This program charge the
battery using the current you
set up. In the “auto” state, you
should set up the upper limit of
the charge current to avoid
damage by excessive feeding
current. Some batteries of low
resistance and capacity can
lead to higher current in the
“auto” charging mode. But in
the manual mode, it will charge
with the current you set. You
can make it blink in the current
field and press INC and DEC at
the same time to switch mode.
Discharge
current
The screen indicates the
discharging state. You can
press START/ENTER key to
alter discharge current. Press
START/ENTER again to store
the value. Press BATT
TYPE/STOP key to stop
discharging. The emitted
sound alerts the end of
discharging.
Battery
type
Battery
voltage
Elapsed
time
Discharged
capacity
NIMH 1.0A 7.42V
DSC 022:45 00890
Batt type
Stop
Start
Enter
‘>3 seconds’
DEC
INC
DEC
INC
Set charge current on the left
and the final voltage on the
right. Range of the charge
current is 0.1-1.0A; range of
final voltage is 0.1-25.0V. Press
START/ENTER key for more
than 3 seconds to start the
program.
Set charge current on the left
and the final voltage on the
right. Range of the charge
current is 0.1-1.0A; range of
final voltage is 0.1-25.0V. Press
START/ENTER key for more
than 3 seconds to start the
program.
The screen shows the real-time status. Press BATT TYPE/STOP key
to end the program. The sound will emitted to indicates the end of
program.
-
+
-
+
Discharge of NiCd/NiMH battery
Charging of NiCd/NiMH battery
NIMH DISCHARGE
1.0A 11.5V
To Next Page
Loading...
