To avoid short circuit between the charge lead always connect the
charge cable to the charger first, then connect the battery. Reverse
the sequence when disconnecting.
Do not connect more than one battery pack to this charger at
any one time.
Never attempt to charge or discharge the following types of
batteries.
“ A battery pack which consists of different types of cells
(including different manufacturers)
“ A battery that is already fully charged or just slightly
discharged.
“ Non-rechargeable batteries (Explosion hazard).
“ Batteries that require a different charge technique from
NiCd, NiMh, LiPo or Gel cell (Pb, Lead acid).
“ A faulty or damaged battery.
“ A battery fitted with an integral charge circuit or a
protection circuit.
“ Batteries installed in a device or which are electrically
linked to other components.
“ Batteries that are not expressly stated by the
manufacturer to be suitable for the currents the charger
delivers during the charge process.
Please bear in mind the following points before commencing
charging:
“ Did you select the appropriate program suitable for the type of
battery you are charging?
“ Did you set up adequate current for charging or discharging?
“ Have you checked the battery voltage? Lithium battery packs
can be wired in parallel and in series, i.e. a 2 cell pack can be
3.7V (in parallel) or 7.4V (in series).
“ Have you checked that all connections are firm and secure?
Make sure there are no intermittent contacts at any point in the
circuit.
“
To Next Page
Loading...
