Immergas DIM 2 ZONE ERP - Use and Maintenance Instructions; General Warnings; Warnings for the User; Cleaning the Case

14
INSTALLERUSER
MAINTENANCE TECHNICIAN
2
USE AND MAINTENANCE
INSTRUCTIONS
2.1 GENERAL WARNINGS.
If the device must be deactivated temporarily,
act directly on the main switch to power o the
system and work safely
• Attention: using any components that use
electrical power requires the observation of
some fundamental rules:
- do not touch the device with wet or moist parts
of the body; do not touch when barefoot.
- if the device is wall-mounted: do not pull the
electric cables, do not leave the device exposed
to the elements (rain, sun, etc.);
- the device power cable must not be replaced by
the user;
- in the event of damage to the cable, switch the
device o and exclusively contact professionally
qualied sta for replacement;
- if the device is not going to be used for a certain
period, disconnect the main power switch.
2.2 WARNINGS FOR THE USER.
is device does not require any regulation or
control by the user; the opening of the device front
lid is therefore prohibited.
e only operation that the user must perform is
that of periodically checking the water pressure of
the system in the boiler. e boiler pressure gauge
should read a value of between 1 and 1.2 bar.
If the pressure is below 1 bar (with the circuit cool),
restore normal pressure via the lling valve located
in the boiler (see boiler instruction book).
N.B.: close the valve aer the operation.
If pressure values reach around 3 bar, the boiler
safety valve may be activated.
In this case, remove water from a radiator air
vent valve until a pressure of 1 bar is achieved,
or ask for assistance from professionally qualied
personnel.
In the event of frequent pressure drops, contact
qualied sta for assistance to eliminate any
system leakage.
At the end of its service life, the appliance must
not be disposed of like normal household waste
nor abandoned in the environment, but must
be removed by a professionally authorised
company. Contact the manufacturer for disposal
instructions.
2.3 CLEANING THE CASE.
Use damp cloths and neutral detergent to clean
the manifold casing. Never use abrasive or pow-
der detergents.