What does it mean if my Immergas VICTRIX EXA 24 X 1 ErP experiences loss of flame signal?
If your Immergas Boiler experiences a loss of flame signal, it means the burner flame went out unexpectedly after the boiler ignited correctly. A new ignition attempt will be made, and if normal conditions are restored, the boiler will restart without needing a reset.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP shows 'Insufficient system pressure'?
If your Immergas Boiler displays 'Insufficient system pressure', it means the water pressure inside the central heating circuit is not sufficient for correct operation. Check the boiler pressure gauge to ensure the system pressure is between 1 and 1.2 bar. If necessary, restore the correct pressure.
What to do if my Immergas Boiler shows a safety thermostat block (over-temperature)?
If your Immergas Boiler goes into overheating block, it means a fault caused excessive overheating internally during normal operation. To fix this, press the Reset button.
What to do if the Immergas Boiler system pressure is insufficient?
If the Immergas Boiler displays insufficient system pressure, it means the water pressure inside the central heating circuit isn't sufficient for proper operation. Check the boiler pressure gauge to ensure the system pressure is between 1 and 1.2 bar. If it's not, restore the correct pressure.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP has insufficient system pressure?
If your Immergas Boiler shows insufficient system pressure, check the boiler pressure gauge to ensure the system pressure is between 1 and 1.2 bar. If necessary, restore the correct pressure.
What to do if my Immergas Boiler experiences a loss of remote control communication?
If your Immergas Boiler loses communication with the remote control, power cycle the boiler. If the Remote Control is still not detected on re-starting, the boiler will switch to local operating mode, i.e. using the controls on the control panel.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP shows 'Block for exceeding the maximum accumulated time, close gas valve opening'?
If your Immergas Boiler displays 'Block for exceeding the maximum accumulated time, close gas valve opening', it means the gas valve remained open longer than necessary without the boiler igniting. To fix this, press the Reset button.
What does it mean if my Immergas VICTRIX EXA 24 X 1 ErP displays 'High temperature block on return probe'?
If your Immergas Boiler displays 'High temperature block on return probe', the heat exchanger return circuit has reached a temperature that is too high. Ensure water circulates properly in the boiler and that the three-way valve is working correctly. To clear the block, press the Reset button.
What does it mean when my Immergas Boiler shows a flue safety thermostat block?
If your Immergas Boiler blocks due to excessive flue gas overheating during normal operation, press the Reset button to resolve the issue.
Why is my Immergas Boiler showing a fan anomaly?
If your Immergas Boiler displays a fan anomaly, it means the fan likely has a mechanical or electrical fault. To attempt to resolve this, press the Reset button.
To Next Page
General