Spare parts and Upgrades
Several crash kits, and upgrades, are available for the Vortex 150/180 Mini, including the following:
Replacement ESC, 30A
Replacement PDB - Vortex 230 Mojo
Replacement Synergy (which includes the vTx)
Crash Kit 2, top plate + battery pad
Crash Kit 3, arm assembly + plastic cover
Vortex 230 Mojo front section - camera holder etc.
Flat-flex, camera, receiver, U.FL->SMA cables
Spare motor, 2206 2300kV
Vortex 230 Mojo pimp kit - white
Vortex 230 Mojo pimp kit - black
Vortex 230 Mojo pimp kit - blue
Vortex 230 Mojo pimp kit - red
Vortex 230 Mojo pimp kit - orange
Vortex 230 Mojo pimp kit - yellow
Vortex 230 Mojo pimp kit - green
Vortex 230 Mojo - all screws and standoffs
Please contact your reseller for ordering any spare parts required.
Support
First line of support is handled by the reseller. If you encounter any problems with your ImmersionRC
product please contact them first.
For support on issues involving equipment from other brands and also general support for ImmersionRC
products, the best place to go is the ImmersionRC section of FPVlab.com.
We actively monitor this forum and provide support here.
A very active Facebook Group is also a good place to go with support, or any other pre/post sales
inquiries for the Vortex product line:
https://www.facebook.com/groups/ImmersionrcVortex
As a last resort, ImmersionRC runs a global network of repair and support centers. These handle warranty
repairs, supply hard-to-find spare parts, and also handle non-warranty work.