EasyManua.ls Logo

Immersion RC Vortex 230 Mojo - Frequently Asked Questions

Default Icon
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Send an email to repairs@immersionrc.com to open a support ticket.
Frequently Asked Questions
Q. How do I calibrate my ESCs?
DO NOT CALIBRATE THEM! ImmersionRC ESCs use quality components with accurate timing and never require
calibration!
Q. Can I fly in the rain?
ImmersionRC is one of the only companies in the racing quad business which conformally coats key PCBs to
add a level of water-resistance. This avoids problems when flying in very humid areas, occasional crashes in
wet grass, and the occasional use of the front of the quad as a snow-shovel.
That said, not all components like getting soaked, the R/C Rx for example, or the sensitive video transmitter
module. For this reason, flying in the rain (which isn’t much fun anyway) is not really recommended.
Q. I dunked my Vortex in the ocean/lake/pond, what do I do?
First thing to do (especially where highly corrosive salt water is involved) is to rinse the entire quad in distilled
water (available where car parts are sold, used to refill car batteries).
This rinsing process will remove potentially conductive salts from the water, and will ensure that they don’t
remain after drying.
Once the quad is rinsed, place it in a zip-lock bag filled with rice, and leave it in a warm place for at least 48
hours. The rice will absorb the remaining water, and increase the chances of life for your quad after the dunk.
Q. My motors are ‘stuttering’, and the quad falls out of the sky under full throttle
This is almost always due to motor screws touching the windings. Motor screw length on any mini-quad is
absolutely critical, especially for ‘upgrade’ motors which have extremely thin base material.
Q. My R/C Receiver isn’t auto-detected by the wizard
Normally, the Vortex will start up in a receiver ‘auto-detect’ mode which will automatically identify the
connected PPM/SBUS/DSMX. Receiver.
From time to time (for reasons not yet understood) this process fails. To work around this, simply connect the
quad to a PC/Mac and using the Vortex Configurator manually set the receiver type.
Q. I don’t like the stock camera, and would like to upgrade it
With previous Vortex quads, which shipped with a CMOS camera, there were clear reasons to do this. For the
Vortex 230 Mojo, we have installed a top-of-the-line CCD camera, with integrated OSD control, and a wide
GoPro lens, why would you want to upgrade that?
Q. My Vortex is playing Crazy Train song
The tunes is emitted by ESC when overvoltage is detected (> 17.4 V). For the 30A ESCs, the maximum voltage
tolerated is that supplied by 4s HV LiPo packs.
45