Need help?Do you have a question about the IMMI SMARTDOCK and is the answer not in the manual?
General| Brand | IMMI |
|---|---|
| Model | SMARTDOCK |
| Category | Docking Station |
| Language | English |
Adjust the SmartDock head to be at least as high or slightly higher than the SCBA bottle.
Loosen socket head cap screws to adjust the wing to its most rearward position.
Grasp the yellow side of the claw and pull it out while rotating it up to open the mechanism.
Adjust the lower adjustment knob to fully seat the lower claw for the SCBA bottle size.
Place SCBA cylinder valve into the lower claw and push the cylinder top into the head.
Turn the height adjustment knob counterclockwise to lower the head until it touches the cylinder top.
Swing the wing forward until it touches the SCBA cylinder and tighten wing adjusting screws.
Ensure the lower adjustment knob contacts the bottle and forces it to the front of lower claws.
To Next Page
