IMMI SMARTDOCK - Adjust Head Height; Final Wing Adjustment; Final Lower Knob Adjustment

Step 6. Adjust Head Height
During normal operation, the SmartDock head should just
touch the top of the SCBA air cylinder. Adjust the head height
by turning the height adjustment knob counterclockwise to
lower the head until the gap between the top of the SCBA air
cylinder and the bottom of the SmartDock head is eliminated.
The top of the SCBA air cylinder should be just touching the
bottom of the SmartDock head.
Step 7. Final “Wing” Adjustment
The SmartDock “wing” holds the SCBA
air cylinder in the proper orientation and
helps close the head when inserting the
SCBA air cylinder into the SmartDock.
The head will not properly close if the
wing is improperly adjusted.
Holding the SCBA air cylinder forward
against the two front claws, loosen the
two wing adjusting screws, swing the
wing forward until it touches the SCBA
air cylinder, and then tighten the wing
adjusting screws to 30 N-m.
Height
Adjustment
Knob
No Gap
Wing Adjusting
Screw
Wing
Swing Wing
Forward
Against Air
Cylinder
Air
Cylinder
Forward
Step 8. Final Lower Knob Adjusment
With the bottle in the SmartDock, the lower
adjustment knob should contact the bottle and
force it to the front of lower claws.
9
SmartDock
®
Installation | User’s Guide
Lower
Knob