IMPPUMPS NMT MAX Series - Turning On and Off; Pump Modes and Parameters; Pump Operation Lock

32

 5secondstogetherwithlongpresson
and keystorestorepumptofactorysettings.
Key
Shortpress:
 Scrollingthroughparametersupwardswhennotchangingparametervalues,
 Scrollingthroughmodesupwardswhenmodeselectionisselected,
 Changingparametersupwardswhensettingparametervalues.
Longpress:
 3secondstogetherwith
putsusinnightmode,
 5secondstogetherwith
and keystorestorepumptofactorysettings.
5.1.1.2 TURNINGONANDOFF
Onfirststartupthepumpwilloperatewithfactorysettingsinautomaticmode.
Withsubsequentstart‐ups,thepumpwilloperatewiththelastsettingsthatweresetpriortoitsshut‐down.
Toswitchthepumpoff,pressandholdthe
keyfor5seconds,untilOFFisshownonthedisplay.Whenthepump
isswitchedoff,thenumericaldisplayshowsOFF.
Toturnthepumpon,pressthe
keybriefly.
5.1.1.3 PUMPMODESANDPARAMETERS
Fortransitionbetweenmodes,weholdthe keyfor3secondsandthenselectthemodeinwhichwewishthe
pumptooperatewith
or keys.Weconfirmtheselectionwiththe key.
Afterconfirmingthemode,theparameter,whichcanbeset,willautomaticallybedisplayedandblink(exceptfor
automode).Ifnecessary,wesettheparametervaluewith
and keys,thenconfirmthesettingwiththe keyor
justpressthe
keytoacceptthegivenparameter.
Wecanscrollthroughtheparameterswithinamodewith
and keys.Weselecttheparameterthatcanbe
adjusted(seeindividualmode)inthemodewiththe
keyandsetthedesiredvaluewith and keys.Weconfirm
theselectedvaluewiththe
key.
5.1.1.4 PUMPOPERATIONLOCK
Forlockingandunlockingpumpcurrentpumpmodeandparameters,hold and keysfor3seconds.Whenthe
pumpislocked,itispossibletoturnthepumponandoff,viewparametersandresetthepumptofactorysettings
thatalsounlocksthepump.
