IMPPUMPS NMT MAX Series - Modbus Communication; Resetting to Factory Settings

35


5.1.6 MODBUS

OnlyavailableonNMT(D)MAXC.
PumphasbuiltinModbusclient,throughwhichwecanaccesspumpinformationusingtheRS485standard.
Modbusallowsustosetandview:
 Regulationmodesettings,
 Regulationparameters(power,RPM,head,flow),
 Relaysettings,
 Externalcontrolinputssettings,
 Currentandpreviewserror,
 Pumpstatistics(powerconsumption,runtimeandother).
5.1.7 RESETTINGPUMPTOFACTORYSETTINGS

Forresettingthepumptofactorysettingsallthreebuttonsmustbeheldfor5seconds.Thiswaythepumpwillset
itselftoautomaticmode,deletepreviousheightandpowersettingsandunlocksettingpumpoperation(iflocked).
Resettingofcommunicationsmoduleneedsfollowingsteps:
1. Disconnectingpowerfrompump,
2. Setthe10‐stepswitchtonumber9
8
(or8forlefttwinpump),
3. Turningthepumponandoffagain,
4. Settingthe10‐stepswitchtonumber1,
5. Turningthepumpon.
Communicationsmoduleshouldnowbesettofactorysettings.


8
Thisalsosetsuptherighttwinpump.