Inalto ICG905W - Cleaning and Care; Appliance Cleaning and Maintenance

10
CAUTION: Ensure the appliance is o and cool
before cleaning.
TRIVETS
Persistent stains may require rubbing with a
nylon scourer or creamed powder cleansers.
Household enamel cleaners are available, follow
the manufacturer’s instructions in their use.
Harsh abrasive cleaners, powder cleaners,
steel wool or wax polishes should not be used.
STAINLESS STEEL HOB
Simply wipe with a soft cloth using warm water
and a mild detergent and rinse with clean water.
Where stainless steel has become extremely
dirty or discoloured, use a stainless steel cleaner
– but be sure to follow the brushing lines.
CAUTION: Do not use abrasive cleaners or
harsh solvents.
IMPORTANT: Do not use scrapers to clean your
hob – it will cause damage.
CAUTION: Try to clean up and remove spillages
immediately, while the hob is still hot! Especially
sugar and foods with a high sugar content
(eg. jam), melted plastics and foil, all of which
can damage the hob if left.
GLASS ON MODELS WITH DECORATIVE
GLASS PANEL
The specially glass within the product is
toughened and designed for both safety and
reliability. However, it must be remembered that
as it is GLASS, it may break. Treat it accordingly.
To clean the glass panel use a soft cloth or
sponge with detergent and warm water.
TRIVETS AND BURNERS
These can all be lifted o and removed for
separate cleaning.
NOTE: When retting the burners, ensure that
they are correctly seated.
Ensure burners are thoroughly dried after
cleaning or spillage. When cleaning the burners,
ensure that all the ame ports are free of any
blockage (refer to Figure 2B on page 6). If
necessary, use a toothpick or brush to clear
ports. The outer surface of the burner caps have
a polished nish and extra care needs to be taken
to avoid scratching this surface during cleaning.
In instances of heavy soiling, it may be necessary
to apply a non-abrasive cleaning compound and
rub with a cloth until the soiling is removed and
then nish with a soft, dry cloth.
NOTE: NEVER place trivets or burners in the
dishwasher.
IGNITION SPARK PLUG AND FLAME
SAFEGUARD SENSOR
GENTLY clean the ignition spark plug and ame
safeguard sensor with a damp cloth to avoid
lighting diculties. Ensure that they are dry
before use.
INJECTOR
Ensure the injector remains free of any foreign
material. If necessary, use a thin piece of wire to
clear the orice.
Cleaning and Care