Inalto ICG905W - Installation and Setup; Installation Standards and Guidelines; Benchtop Cutout and Clearances

13
This appliance must be installed by an authorised
person and in compliance with:
• AS/NZS 5601.1 Gas Installations Part 1:
General Installations, and AS/NZS 5601.2
Gas Installations Part 2: LP Gas installations
in caravans and boats for non-propulsive
purposes, or the relevant installation code for
gas appliances in your country.
• The local gas tting regulations, municipal
building codes, electrical wiring regulations
and any other relevant statutory regulations.
• The particular instructions as given below.
• A certicate of compliance MUST be given
to the customer after the application is
successfully installed.
CAUTION: Cooktops are supplied set up for
natural gas (NG). To use on LPG, the injectors
must be changed using the conversion kit
supplied. Refer LPG Conversion on page 20.
Installation Instructions
Figure 5  ICG905W
* Minimum clearance from cut-out to combustible surface.
NOTE: This dimension is not relevant if the adjacent surface is non-combustible.
860
510
490
Gas Supply
Connection
136*
100*
124*
835