Inalto ICG905W - Before First Use; Installation and Servicing Requirements; Controls and Initial Lighting

7
Before First Use
INSTALLATION
• An authorised person must install this
appliance and MUST provide a Certicate
of Compliance. This certicate should be
retained along with purchase information.
• Before using the appliance, ensure that all
packing materials are removed from the
appliance.
• In order to avoid any potential hazard, the
installation instructions in this booklet, and
any labels on the appliance must be followed.
• Ensure that all specied vents, openings and
air spaces are not blocked.
• Where the appliance is built into a benchtop,
the benchtop material must be capable of
withstanding 85°C.
• Ensure that the duplicate rating label (in the
instruction pack) is attached to a readily
accessible adjacent surface, so that the
cooktop can be easily identied in the case of
a service call.
SERVICING
• Servicing MUST only be carried out by
authorised personnel.
• To maintain safe operation, it is
recommended that the product be inspected
every ve years by an authorised service
person.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualied persons in order to
avoid a hazard.
WARNING: Never install a cooktop that has
been damaged. Please contact our Service Team
for assistance.
CLEANING
• Always ensure the appliance is turned o
before cleaning.
• This appliance contains aluminium ttings.
Do not use caustic based cleaners.
• Do not use steam cleaners as this may cause
moisture build up on electrical components.
• Always clean the appliance immediately after
any food spillage.
• Do not place any components in a
dishwasher.
• Refer to the Cleaning and Care section on
page 10 of this user manual for instructions on
cleaning and maintaining your stainless steel
hob panel.
CAUTION: Never place burners or trivets in
a dishwasher.
CONTROLS
Each burner is controlled by a control knob.
The markings on the control panel indicate which
burner the knob controls, and the setting for that
burner (see Figure 3).
LIGHTING BURNERS
Electronic ignition: These cooktops are tted
with mains powered ignition. When the
appliance has been connected and the power is
on, depressing any knob will release sparks to
all burners.