Inalto ICG905W - Securing the Cooktop

15
Figure 6 FITTING THE CLAMPS
• Ensure that the hob is free from all burner
pieces and trivets. Place the hob upside down
on a soft surface to protect both the hob and
your worksurface from damage.
• Place the bracket (B) over the holes that
match the size of the screws. There are one
set of screw holes in each corner of the hob.
Slightly tighten a screw (C) through the
bracket (B) so that the bracket is attached to
the hob whilst still allowing you to adjust it’s
position.
• Carefully turn the hob back over and then
gently lower it into the aperture hole that you
have cut-out in your benchtop.
• On the underside of the hob, adjust the
brackets into a position that is suitable for
your benchtop. Then fully tighten the screws
(C) to secure the hob into position.
(A) SEALING STRIP
INSTALLATION PROCEDURE
1.
The bench cutout should be made as per cutout
dimensions in Table 2 and Figure 5.
2.
Adjacent walls, cupboards and protection for
combustible materials: Ensure that the appliance
is installed in accordance with AS/NZS 5601.1,
or AS/NZS 5601.2 with regard to clearances to
combustible surfaces and materials, and clearances
to rangehoods and exhaust fans.
To ensure clearances of 200mm from burners to
vertical combustible surfaces observe the minimum
distance requirements shown in Figure 5.
Clearances to combustible surfaces may be reduced
if combustible surfaces are protected in accordance
with AS/NZS 5601.1, or AS/NZS 5601.2.
3. Barrier: A barrier must be installed to prevent
accidental contact with the cooktop base, where the
base of the cooktop is accessible from below (i.e.
Inside a cupboard, etc.). A minimum clearance of
15mm must be maintained between the base and
the barrier. This barrier may be made of any non-
combustible, rigid material.
Barrier protection is not necessary if the product
is installed above an underbench oven or similar
appliance and/or if the cupboard construction is such
that the underside of the cooktop is not accessible.
4. Ensure that there is an earthed power outlet
within 900mm of the rear right hand side of the
cooktop when installed. This should be
accessible at all times.
5. A self-adhesive Foam Tape has been provided to
act as a sealing agent and is to be placed around
the edge of the hob underside. Ensure that there
are no gaps in the Foam Tape. Take care to
ensure that the seals meet without overlapping.
The thickness of this Foam Tape is 3mm and the
width is 10mm.
6. Fit the pull down clamps supplied to ensure that the
cooktop cannot move after installation. Refer to
Figure 6 and the instructions below.
7. Remove any excess seal visible after installation.
WARNING!
Failure to fix the cooktop
to the bench could result in
loosening of the gas connection through movement of the
cooktop and a gas leak may result.
Clamps and screws are supplied with each cooktop.
Fit the clamps as shown in Figure 6.
When benchtops are less than 35mm in thickness, it may
be necessary to fit a spacer between the benchtop and
each clamp to ensure clamps can be tightened sufficiently.
Figure 6
(B) CLAMP(C) SCREW