Inateck BCST-73 - Disconnecting Paired Receivers; Bluetooth Connection Mode

4
EN
d)Athree-chordsound(fromlowtohigh)indicatesasuccessfulpairing.Oncethereisa
longhightone,itmeansthepairingfailsandarepeatedoperationisneeded.
Topairmorescannerswiththeadapter,pleaseoperateasthestepsmentionedabove.
3)HowtoDisconnectaReceiver
Ifyouhavepairedthescannerwithtwodifferentreceivers,thesetworeceiverscan
both connect thescanner.Ifyouwanttodisconnectoneofthem,pleasefollow
thestepsbelow:makesurethescannerisconnectedwiththereceiverthatshould
bedisconnected,andthenscanthebarcodesinturn“EnterSettings”-“Disconnect
Receiver”-“SaveandExit”.Thescannerwilldisconnectfromthereceiver.
（*）DisconnectReceiver
BluetoothMode(HID)
TheBluetoothmode(HID)isnotadefaultmode.Toswitchtothismode,pleasescanthe
settingbarcodesinsequence"Entertosetup"-"BluetoothMode(HID)"-"ExitwithSave"
ExitwithSave
BluetoothMode(HID)
EnterSetup