Inax SATIS S - General Freezing Prevention Procedure; Intermittent Flushing to Prevent Freezing; If the Water in the Tank Is Frozen

Useful Information
33
Useful Information
If the Water in the Tank is Frozen
The water in the shower toilet may freeze and cause damage during winter or other times when the water temperature
is signi cantly low.
Perform the following procedure to prevent freezing and related damage.
Do not disconnect the power plug from the outlet. Leave the power turned on. Turn off any active power save function.
󱫀
Set the
【
Seat Temp.
】
to "High" and close the toilet lid
(
☞
Page 11).
󱫂
Turn off any active power save function (
☞
Page 27).
󱫄
Heat the toilet room.
󱫀
Set the
【
Seat Temp.
】
to "High" and close the toilet lid
(
☞
Page 11).
󱫂
Turn off any active power save function (
☞
Page 27).
󱫄
Press and hold both the
【
Massage
】
and
【
Nozzle
Cleansing
】
buttons for at least 2 seconds.
* Each pressing of these buttons will turn the function on and off.
* Flush the toilet every 6 minutes to prevent freezing.
If the toilet room can be heated: Refer to the "General Freezing Prevention Procedure" section.
If the toilet room cannot be heated:
Refer to the "Intermittent Flushing to Prevent Freezing" section or
"Draining the Water to Prevent Freezing" section.
Make sure to follow one of the
freezing prevention procedures
whenever there is a possibility of
freezing.
* Damage from freezing may cause  re
or  ooding.
OBSERVE
CAUTION
General Freezing Prevention Procedure
Intermittent Flushing to Prevent Freezing
【
Seat Temp.
】
【
Massage
】
+
【
Nozzle Cleansing
】