Cleaning and Maintenance
43
Cleaning and Maintenance
The nozzle can be ejected for cleaning or to replace tips.
The nozzle shutter can be opened and removed, and the deodorizing lter can also be removed.
[Ejecting Nozzles]
Turn off both
【
Auto Clean
】
and
【
Auto
Seat Open
】
(
☞
Page 19 and 20).
* If these functions are not turned off, water could
ow or the toilet seat could close unexpectedly
when the toilet detects the presence of a person.
* Do not forget to turn the functions back on after you
have nished cleaning.
Open the toilet seat lid and the toilet seat.
[CAUTION]
Do not apply excessive force to nozzles.
* Doing so may cause malfunction.
Do not manually force the nozzle forward or backward.
* Doing so could cause a malfunction such as the nozzle not moving correctly. If the nozzle is incorrectly pulled
forward or pushed backward, disconnect the power plug from the outlet and wait approximately 10 seconds
before reconnecting the power plug.
Do nut scrub with a toothbrush.
* Doing so may cause damage.
Press the
【
Nozzle Cleansing
】
button.
* Water will discharge from a point near the nozzle
tip for approximately 5 seconds and then the rear
nozzle will extend forward. The shower spray will
discharge at this time.
* The nozzle will automatically retract after
approximately 5 minutes.
After the nozzle has retracted, press the
【
Nozzle
Cleansing
】
button again to extend the rear nozzle
again.
Press the
【
Nozzle Cleansing
】
button.
* The rear nozzle retracts followed by ejection of the
front nozzle.
【
Nozzle Cleansing
】
【
Auto Clean
】【
Auto Seat Open
】
* The nozzle will automatically retract after approximately 5 minutes.
After the nozzle has retracted, press the
【
Nozzle Cleansing
】
button two times to extend the front nozzle again.
Press the
【
Nozzle Cleansing
】
button.
* The nozzle shutter opens.
* The nozzle shutter opens to enable removal of the shutter or cleaning of the deodorizing lter.
* Refer to the "Removing the Nozzle Shutter" and "Cleaning Deodorizing Filters" sections. (
☞
Page 44)
Press the
【
STOP
】
button to return the nozzle shutter to the original position.
* If the nozzle catches, perform the procedure to eject the nozzle again.
Cleaning Nozzle Areas
To Next Page
