Reproducing
an
exact
cut
width.
Position the piece
to
be reproduced against the fence and
leave
some space next to the blade. 1" would be ade-
quate. Using the piece to be copied
as
a fence, cut a
piece
of
scrap. Do not move the fence.
The scrap will replace the piece and now any other piece
run through agaiinst the scrap will be aucomaticall
the same size
as
the original piece.
It
is
repeatable and requires no measurement,
no
set-up.
Steel die-makers use this technique to saw blockes
of
ply-
wood
to
precise dimensions.
Page
10
To Next Page
Loading...