27
Page 27 - 2 Tank Sentinel Setup Programming Guide
DISPLAY Navigation/Descriptions (C
ONTINUED
...
FROM
PREVIOUS
PAGE
)
Descriptions —
Please read the following descriptions of each DISPLAY menu:
CPM — shows the current state of the system: VOLTS, AMPS and STATUS
AST — shows current pressure reading for each pressure probe: PSI
SCALD — shows the current status and algorithm version
PUMPS — shows many readings from a Turbine Pump Controller
Special PUMPS navigation —
• Press the (
M
) key aligned below the word PUMPS,
• Press the (
M
) key under each pump number,
(In this example, press the
M1
key for PUMP 1 data)
— continued on the next page —
CPM VOLTS AMPS STATUS
15.4 8.7 OK
SCALD TANK1 TANK2
STATUS 0.02 0.02
SETUP MENU OPTION
SCALD PUMPS
M1 M2 M3 M4
M1 M2 M3 M4
SELECT PUMP (MORE)
PUMP 1 PUMP 2 PUMP 3 PUMP 4
To Next Page
Loading...
