32 QUICK START GUIDE INCOTEX 500F
Wait until the process of installation is completed.
When the Setup has completed the installation of “Incotex”, click Finish.
After finishing the installation the computer will restart.
5.4. Installing a Server
If the ESD will be used in a network the 'setup_server.bat' has to be run on the host server. This is not
necessary if only one PC will be used.
Caution: If the 'setup_server.bat' has already been run but isn't going to be used (this is not your
server PC, or you will use only one PC) it has to be uninstalled. To do this follow the steps below:
To Next Page
Loading...