Indel B SW CUBE 12V User Manual

7.3 - ERRORS
In case of a problem, the device shuts down and the display will show one error message from the following list.
Message Description Troubleshooting
E1
Battery power
(The battery-saver has activated. Power
decreased below the set threshold.)
Start the vehicle in order to recharge the
battery.
E2
Power overload from the cooling fan
(The cooling fan overloads the board beyond
the allowed limit. Possible cause: short circuit or
something is blocking the fan from rotating.)
Take the device to an authorised dealer.
E3
Blocked compressor
(The rotor is blocked or the pressure in the
cooling circuit is too high.)
The presence of E3 – E4 – E5
codes do not
indicate a malfunction, but is a normal
management procedure for the compressor by
the electronic board. Only if the code continues
to be displayed contact an authorized dealer.
E4
Minimum compressor rotation speed
(If the cooling circuit is overloaded, the
compressor is unable to maintain minimum
rotation speed.)
E5
High temperature in the control board
(If the cooling circuit is overloaded or if the
surrounding temperature is too high, the control
board signals this issue.)
E6
Communication error
(No communication between the display and the
control board.)
Take the device to an authorised dealer.
E7
Temperature probe
(If the probe has short circuited or has become
disconnected, the device stops working.)
E9
Power overload from the condenser fan
(The cooling fan overloads the board beyond
the allowed limit. Possible cause: short circuit or
something is blocking the fan from rotating.)
40
SW CUBE 12V
SW_CUBE_12V_20-02-2019

Indel B SW CUBE 12V Specifications

General

Brand	Indel B
Model	SW CUBE 12V
Category	Air Conditioner
Language	English