Indramat TDA 1 - AS Programming Module Compatibility; AS Programming Module Versions

32
• DOK-DIAX01-TDA********-PRJ1-EN-E1,44 • 07.97
3. Programming Module AS
The application-related parameter values calculated by INDRAMAT are
contained in the associated programming module AS.
Application-related parameters are assigned standard values. The ma-
chine-related and application-dependent parameters are entered in the
module on site.
The documentation and management of these machine- and applica-
tion-related parameters is the responsibility of the customer.
If a programming module which has been assigned machine- and
application-related parameter values is to be documented, managed
and supplied by INDRAMAT, a customised programming module is
created. This is done on customer request after consultation with
INDRAMAT and is subject to an extra charge.
The latest state of the art (updating of the programming module AS) for
operation of the drive is supplied without any change being made to the
ordering code (type designation) of the programming module. Updated
programming modules are compatible with programming modules al-
ready in the field.
The drive is guaranteed always to operate to the latest state of the art
although no change has been made to the ordering code of the program-
ming module.
This means:
– debugging of software errors
– extension of the scope of functions without any impairment to existing
functions
– improved parameter values for the motor/controller combination
Standard
3.1. AS programming
module versions
3.2. AS programming
module compatibility
Customised
(for mass-produced ma-
chines)
Updating of the program-
ming module AS