BOOSTER
WITH LAP-SASH SEAT BELT
Place the child restraint in the car, in a forward facing
seating position (Refer to Figure 1)
Install the upper anchorage tting as shown on page
3 & 4 of these instructions
Hook the attachment clip to the anchor tting. Ensure
there are no twists in the upper anchorage strap
(Refer to Figure 2)
Pull to tighten to remove all the slack, from the upper
anchorage strap. (Refer to Figure 2) Do not
overtighten as this could cause the restraint to lift off
the vehicle seat.
ADJUSTING RECLINE ANGLE
Determine which angle is prefered for the
comfort of your child.
TO RECLINE
Pull down the recline base and ensure the
support is forward (in position).
Always use upper anchorage strap to attach
the child restraint to the vehicle.
Do not use the restraint without the upper
anchorage strap correctly attached and
adjusted.
Do not use on any vehicle seat which faces
sideways or rearwards.
IF AN AIRBAG IS FITTED IN THE SEATING
POSITION WHERE THE CHILD RESTRAINT
IS TO BE FITTED, FOLLOW THE VEHICLE
MANUFACTURER’S WARNINGS AND
INSTRUCTIONS.
Fit the restraint rmly to the car seat.
WARNING
!
ADJUSTER
ATTACH
PULL TO
TIGHTEN
Tilt
Pull to
lengthen
Pull to
tighten
RECLINEUPRIGHT
21
To Next Page
Loading...
