16
Installation
Child Car Seat
ADJUSTER
ATTACH
PULL TO
TIGHTEN
Installing Using Vehicle Seatbelt
Pull to
Lengthen
Pull to Tighten
Figure 9Figure 12
Figure 9Figure 11
Step 5:
Step 6:
Step 7:
Note: If no upper anchorage tting is available refer to
Pages 40 & 41.
Hook the attachment clip to the anchor tting. Ensure
there are no twists in the top tether strap (refer to
Figure 11).
Pull to tighten to remove all the slack, from the upper
anchorage strap. Do not overtighten as this could
cause the restraint to lift off the vehicle seat (refer to
Figure 12).
Roll up and store any excess webbing, from the top
tether strap, in the storage pocket provided on the
restraint (refer to Figure 13).
Figure 13
Storage
Pocket
IMPORTANT
!
• Tighten till slack is removed.
• In certain vehicles an extension strap
may be needed.
• Do not overtighten Top Tether strap.
• Ensure Top Tether strap is passed
through the Top Tether Strap Guide.
CAUTION: CHILDREN CAN BE
INJURED OR RESTRAINTS AND
TOP TETHER STRAP DAMAGED
BY UNSECURED CARGO IN A
COLLISION. SECURE OR
REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD
RESTRAINT.
Always secure the loose end of the
top tether strap to prevent it
hanging out of the car or being
accessible by the child.
Tether Storage
After correctly installing the restraint in your car,
roll up and place any excess tether strap in the
storage pocket provided (refer Figure 13).
To Next Page
Loading...
