Installation
Infant Seat
FOLLOWING THE INSTALLATION OF
THE CHILD RESTRAINT A SMALL
AMOUNT OF MOVEMENT IS DEEMED
ACCEPTABLE.
NOTE
IMPORTANT
!
• Tighten till slack is removed.
• In certain vehicles an extension strap
may be needed.
• Do not overtighten Top Tether strap.
• Ensure Top Tether strap is passed
through the Top Tether Strap Guide.
Pull to tighten to remove all the slack, from the upper
anchorage strap. Do not overtighten as this could
cause the restraint to lift off the vehicle seat (refer to
Figure 9).
Step 7:
Installing Using Vehicle Seatbelts
CAUTION: CHILDREN CAN BE
INJURED OR RESTRAINTS AND
TOP TETHER STRAP DAMAGED
BY UNSECURED CARGO IN A
COLLISION. SECURE OR
REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD
RESTRAINT.
Always secure the loose end of the
top tether strap to prevent it
hanging out of the car or being
accessible by the child.
Tether Storage
After correctly installing the restraint in your car,
roll up and place any excess tether strap in the
storage pocket provided (refer Figure 10).
Figure 9
Figure 10
Top Tether
Strap
Adjuster
Storage
Pocket
Top Tether
Strap Guide
Top Tether
Strap
Anchorage
Point
Adjuster
To Next Page
Loading...
