24
Use
Infant Seat
Using in-built harness
IMPORTANT
!
A LOOSE HARNESS IS DANGEROUS.
The Padded Insert/s (if tted) are designed to
provide extra support and comfort for small
babies. Discontinue use when the insert is a
tight t or creates discomfort for larger
babies/children.
Always adjust the height of the shoulder straps
as the child grows.
NOTE: If Top Tether strap has been loosened to allow
easier placing of the baby in the restraint, tighten the
upper anchorage strap so it has no slack in it. DO
NOT TIGHTEN EXCESSIVELY.
Check the harness tightness by the PINCH TEST ,
this is acheived by pinching the harness webbing at
the shoulders (refer Figure 7)
• If you can pinch the harness strap, tighten more.
• If your ngers slip off, then the harness is tight
enough.
If required repeat Step 5.
Pull to tighten to remove all the slack, from the
upper anchorage strap. Do not overtighten as
this could cause the restraint to lift off the vehicle
seat (refer to Figure 8).
Step 6:
Step 7:
Figure 7
PINCH
TEST
Tether Storage
After correctly installing the restraint in your
car, if you have an excessive amount of strap roll
up and place any excess top tether strap in the
storage pocket provided. Otherwise secure to the
top tether by using the velcro connectors (refer
Figure 9).
Figure 8
Top Tether
Strap Guide
Top Tether
Strap
Anchorage
Point
Adjuster
To Next Page
Loading...
