Infasecure CS8113 - Page 26

25
For Ease Of Use
To release your child from the restraint simply press
the red button on the harness buckle and carefully
remove your child from the restraint (refer Figure 1).
No need to disconnect the Upper
Anchorage Strap.
To access your baby simply;
- Loosen upper anchorage strap
(refer Figure 2).
- Lower strap out of way
(refer Figure 3).
Reverse procedure when reseating the baby.
NOTE: If Top Tether strap has been loosened to allow
easier placing of the baby in the restraint, always
retighten the Top Tether strap so it has no slack in it.
DO NOT OVERTIGHTEN.
WARNING
!
To Release Infant
Use
Infant Seat
Always use a lap or lap-sash seat belt
and top tether strap to attach the child
restraint to the vehicle.
Do not use the restraint without the top
tether strap correctly attached and
adjusted.
Do not use on any vehicle seat which
faces sideways or rearwards.
IF AN AIRBAG IS FITTED IN THE
SEATING POSITION WHERE THE
CHILD RESTRAINT IS TO BE FITTED,
FOLLOW THE VEHICLE
MANUFACTURER’S WARNINGS
AND INSTRUCTIONS.
Do not use the restraint if the buckle
is sluggish or does not provide an
audible “Click” refer to Cleaning
Instructions on page 44.
Always keep adjuster within this region
(refer Figure 2).
Figure 1
Top Tether
Strap
LOWER OUT OF WAY
Top Tether
Strap
Top Tether
Top Tether
Adjuster
Location
Strap Guide
Figure 2
Figure 3