7 Charging
The EYE III series is supplied with a built-in rechargeable Li-ion battery pack,
which allows operation up to 8 hours. When using the device for the first
time, please fully charge it first.
⚫ Connect the Type C end of the data cable (10) to the Type C port (5) of
the device.
⚫ Connect another port of the data cable (10) to the power adapter (11).
⚫ Insert the plug of the adapter to the 110-240V socket (12).
⚫ When the device is charging, the power indicator (6) next to the Type C
port (5) is red. The power indicator (6) is on only in the charging status.
When the power indicator (6) turns green, the device is fully charged.
⚫ When charging, a lighting icon will appear inside the battery icon
on the display. The lighting icon will not disappear until the data cable
(10) is removed or the power is cut off.
⚫ Charging is finished when the interior of the battery icon on the display
is completely green .
⚫ During using, when the battery icon turns red , this means the
power level is low, please charge the device in time to avoid the data
loss.
Safety instructions for battery
⚫ The rated voltage of the product is 5V. Please charge the device
promptly when the battery is low so that the service life of the thermal
imaging monocular will not reduce due to battery over-discharge.
To Next Page
Loading...
Need help?
General
