How to fix a fuzzy or cropped image on InFocus IN3114?
If the image on your InFocus Projector appears fuzzy or cropped, set your computer’s display resolution to the native resolution of the projector. If you are using a laptop, disable the laptop monitor or turn on dual-display mode.
What to do if my InFocus IN3114 says 'Signal out of range'?
If your InFocus Projector displays a computer image with the words “Signal out of range”, press the Auto Image button on the keypad or remote. You may also need to adjust the computer refresh rate (Control Panel > Display > Settings > Advanced > Adapter; location varies by operating system) and/or set a different resolution on your computer.
What to do if there is no start up screen on InFocus IN3114 Projector?
Plug the power cord into the InFocus Projector, then press the power button.
What to do if only start up screen appears on InFocus IN3114 Projector?
If you only see the startup screen on your InFocus Projector, and your computer uses the projector's DisplayLink connector, consult the DisplayLink Software User's Guide for troubleshooting. You can also try pressing the Source button, activating the laptop’s external port, or restarting your laptop.
How to center the image on screen of InFocus IN3114?
To center the image on the screen with your InFocus Projector, physically move the projector and adjust the zoom.
What to do if only my laptop's background appears on InFocus IN3114 Projector?
If your InFocus Projector displays only your laptop's background without the Desktop icons, use the DisplayLink software to switch from Extended Desktop to Duplicated Desktop. Alternatively, disable 'Extend my Windows Desktop' in Control Panel > Display > Settings > Display 2, uncheck the option, and then click Apply.
What to do if my InFocus Projector is too hot?
If your InFocus Projector is too hot, ensure that the vents are not blocked. Turn the projector off and wait one minute before turning it back on. Contact Technical Support if the problem persists.
General| Projection technology | DLP |
|---|---|
| Contrast ratio (typical) | 2100:1 |
| Projector native resolution | XGA (1024x768) |
| Aspect ratio | 4:3, 5:4, 16:9 |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 116.8 x 241.3 x 315 mm |
| Power requirements | 100 - 240 V at 50 - 60 Hz |
| Lamp power | 280 W |
| Light source type | Lamp |
| Service life of light source | 3000 h |
| Service life of light source (economic mode) | 4000 h |
| RMS rated power | 10 W |
| Number of built-in speakers | 2 |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Power consumption (typical) | 228 W |
| Product type | Standard throw projector |
To Next Page
