Need help?Do you have a question about the InFocus IN3102 and is the answer not in the manual?
General| Matrix size | 0.55 \ |
|---|---|
| Projection distance | 1.95/11.02 m |
| Vertical scan range | 50 - 85 Hz |
| Horizontal scan range | 15.75 - 100 kHz |
| Projection technology | DLP |
| Contrast ratio (typical) | 2000:1 |
| Screen size compatibility | 0.99 - 5.08 \ |
| Projector native resolution | XGA (1024x768) |
| Keystone correction, vertical | -30 - 30 ° |
| Interface | USB |
| Aspect ratio | 4:3, 5:4, 16:9 |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 315 x 248.9 x 94 mm |
| Power requirements | 100 - 240 V, 50 - 60 Hz |
| Connectivity technology | Wired |
| Throw ratio | 1.95 - 2.15:1 |
| Lamp power | 230 W |
| Light source type | Lamp |
| Service life of light source | 3000 h |
| Service life of light source (economic mode) | 4000 h |
| Analog signal format system | NTSC, PAL, SECAM |
| Serial interface type | RS-232 |
| Noise level | 33 dB |
| Power consumption (typical) | 228 W |
| Operating temperature (T-T) | 5 - 35 °C |
Weight and Dimensions| Weight | 3180 g |
|---|---|
| Package weight | 6490 g |
Guidance on identifying and resolving common setup issues using status indicators.
Solutions for when the projector displays no startup screen.
How to fix "Signal out of range" errors by adjusting resolution or refresh rate.
Steps to resolve fuzzy or cropped images by adjusting display resolution.
How to adjust aspect ratio for proper screen fit.
How to correct an upside-down image by adjusting the Ceiling Mount setting.
Adjusting color, tint, brightness, and contrast for accurate color reproduction.
Solutions for embedded videos not playing in presentations.
Steps to take when the lamp won't turn on and the temperature light is active.
What to do when the "Replace lamp" message appears and the lamp doesn't turn on.
How to enable, use, and reset the projector's PIN protection feature.
To Next Page
