— 36 —
Advanced 1 Feature
Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu. Press
▲▼ to move to the Advanced 1 menu and then press Enter or ►. Press ▲▼ to move up and down
in the Advanced 1 menu. Press ◄► to enter and change values for setting.
Press ◄► to enter and select different OSD location.
Press ◄► to enter and select OSD background translucent level.
Press ◄► to enter and select Low Power Mode : Off, Low Power, On by Lan or VGA
Out Mode. Low Power mode uses less than 0.5W of power in standby mode and
disables LAN functionality. If you want to be able to turn on the projector via LAN and
use less than 6W of power in standby mode, choose On by LAN instead.
Press ◄► to enter and toggle between Normal and High fan speeds.
Note: We recommend selecting high speed in high temperatures, high humidity, or
high altitude (higher than 1500m/4921ft) areas.
After replacing the lamp, this item should be reset. See page 37 for more information
on Lamp Hour Reset.
Press ◄► to enter and adjust a two digit projector ID from 00 through 98.
Press (Enter) / ► to enter the Network menu. See page 37 for more information on
Network.
Press ◄► to enter and turn Video Overscan on or off.
To Next Page
Loading...
Need help?
General
