How to troubleshoot LiteShow II having no power on InFocus Projector?
If your LiteShow II has no power and the power LED is not lit, verify that the power supply connector is plugged into both the LiteShow II and a working AC power outlet. You can also try performing a hard reset or using a new LiteShow II power cord.
Why is 'Connect to Projector' option unavailable in Windows XP for InFocus LiteShow II?
If the “Connect to Projector” option is unavailable while using Windows XP, it's likely due to the installation requiring Administrator privileges. The "Connect to Projector" option will not work without Administrator privileges. Manually select the Wireless Network through the operating system after LiteShow Manager starts.
What to do if the LiteShow II device is not showing up in LiteShow Manager for InFocus Projector?
If the LiteShow II device isn't showing up in your LiteShow Manager, make sure both the projector and the LiteShow II device are turned on and that the LiteShow II splash screen is displaying. Also, verify the wireless network strength in the LiteShow Manager software. If needed, adjust the antenna angle on the back of the adapter to maximize the wireless network strength.
Provides important safety and compliance information regarding FCC regulations.
Specifies the minimum hardware necessary for the LiteShow II adapter and software.
Details the essential physical connections for setting up the adapter.
Instructions for selecting and connecting to a specific projector.
Process for setting or changing the password to access advanced adapter settings.
Instructions for updating the LiteShow II adapter's firmware.
Steps to restore the adapter to its original factory default settings.
Explains different network configurations: Peer-to-Peer, Access Point, and Enterprise.
Configures security settings like WEP, WPA, and WPA2 for wireless connections.
Procedures for performing soft and hard resets on the LiteShow II adapter.
To Next Page
General
