14
Setting up the Projector
Turning Off the Projector
If you want to blank the screen for a short period of time, press
the
standby
button on the keypad or remote. This blanks the
screen for fifteen minutes, but keeps the projector running. (You
can change the amount of time the projector stays in standby
mode; see “Standby Time” on page 30 for details.) After the
standby time, the projector shuts off. To exit standby mode, press
the
standby
button again.
NOTE: Lamp life will be extended
if you turn the projector off, then
wait 1 minute while the lamp cools
before unplugging the projector.
To completely power off the projector, press the Power button.
The lamp turns off and the LED blinks orange while the fans con-
tinue to run to cool the projector. After the projector is cooled, the
projector turns off and the LED lights solid green.
To Next Page
Loading...
Need help?
General
