37
5
Lift and grasp the metal handle and pull the module out (Fig-
ure 26). Dispose of the lamp module in an environmentally
proper manner.
FIGURE 26
Removing the lamp module
WARNING: Do not drop the
lamp module or touch the glass
bulb! The glass may shatter and
cause injury.
6
Install the new lamp module, being sure to align the connec-
tors properly.
7
Push the module in until it is flush with the case of the projec-
tor.
8
Tighten the three screws on the outside of the module.
9
Replace the lamp door and re-install the seven screws.
10
Plug in the power cord and press the power button to turn the
projector back on. The lamp hour counter in the Status menu
is automatically reset to zero.
To Next Page
Loading...
Need help?
General
