To prevent damage to your projector, please use only approved InFocus ceiling mounts: www.infocus.com/accessories/mounts
If you wish to use a third party ceiling mount kit, please ensure the screws used to attach a mount to the projector meet the
following specifications:
l
Screw type: M4 XL
l
Minimum screw length: 9mm
4.6 MOUNTING HOLE DIAGRAM
If you buy a ceiling mount from another company, please be sure to use the correct screw size. Screw size will vary depending on
the thickness of the mounting plate.
Be sure to keep at least 10 cm gap between the ceiling and the bottom of the projector.
Avoid installing the projector near a heat source.
24
To Next Page
Loading...
