29
Using the audio
Using the projector’s speakers
To use the projector’s speaker, connect your source to the Audio In connec-
tors (L and/or R) on the projector’s composite connectors.
To adjust the volume, press the Volume buttons on the keypad or remote.
To mute the sound, press the Mute button on the remote.
Troubleshooting Audio
If you aren’t hearing the audio, check the following:
• Make sure the audio cable is connected.
• Make sure mute is not active (press the Mute button on the remote).
• Make sure the volume is turned up enough. Press the Volu m e button
on the keypad or remote.
• Make sure the correct source is active.
• Adjust the audio source.
• If playing a video, make sure the playback has not been paused.
Connecting external speakers
The projector can be attached to external speakers that have their own
power source by plugging a speaker cable (not included) into the projector’s
Audio Out connector.
connect audio cable
adjust volume
external speakers
speaker
cable
audio out
with own power source
To Next Page
Loading...
Need help?
General