EonStor DS S12/S16/S24 Series Hardware Manual
Extraction
handle
5. Insert the replacement module. Make sure the extraction handle is held at its
highest position so that the saddle notches on the sides of the handle can snap
onto the metal anchor pins placed along the interior walls of the PSU slot. Push
the PSU into chassis, and when you feel the contact resistance, use slightly more
force to engage the back-end connectors. Push the handle downwards to secure
the module.
6. Fasten the retention screw.
7. Reconnect the power cord.
8. Power on the PSU module.
135
To Next Page
Loading...