EonStor DS S12/S16/S24 Series Hardware Manual
mounted i
n a rack-mount rack, use another hand to support its
weight while removing the module.
WARNING!
It is recommended that the replacement procedure is completed in less than
five (5) minutes to prevent a prolonged disruption to system airflow.
Step 5. Install the replacement module. Make sure the extraction
handle is held at its lowest position so that the saddle notches
on the sides of the handle can snap onto the metal anchor pins
on the interior walls of the PSU slot. Push the PSU into chassis,
and when you feel the contact resistance, pull the handle
upwards to secure the module.
140
To Next Page
Loading...