EonStor DS S12/S16/S24 Series Hardware Manual
4. Remove the drive tray. Pull the tray one inch away from the enclosure. Wait for
at least 30 seconds for the disk drive to spin down, and then gently withdraw the
drive tray from the chassis.
5. Remove four retention screws. The screws secure the hard drive to the drive
tray.
Installing a Hard Drive without a MUX Board (SAS drives)
Installing a Hard Drive with a MUX Board (SATA drives)
6. Replace the drive. After swapping the drive, fasten the retention screws back.
7. Insert the drive tray back to the enclosure. Install the drive tray with the front
bezel open. When fully inserted, close the front bezel.
146
To Next Page
Loading...