EonStor DS S12/S16/S24 Series Hardware Manual
DIMM Slot
Captive Screw
3. Install the replacement module and fasten the captive screw.
4. Reinstall the controller.
NOTE
A replacement BBU takes approximately twelve hours to charge to its full capacity.
The life expectancy of a BBU is three years.
If the cause of a failure cannot be determined even after a BBU module is replaced,
contact your system vendor.
5.3.3 Replacing the FBM
To replace the FBM, follow these steps:
(Top Screw)
(Side Screw)
Top C over
132
To Next Page
Loading...