EonStor DS S12/S16/S24 Series Hardware Manual
Securing PSU Using the Extraction Handle
Step 6. Secure the PSU to the system by fastening the retention
screw through the PSU extraction handle.
Step 7. Replace the power cord that connects the PSU module to the
mains.
Step 8. Power on the PSU module.
5.4.4 Replacing the PSU on S24 RAID System
Step 1. Power off the PSU. The power switch is located on each
PSU’s rear panel.
Step 2. Disconnect the power cord that connects the PSU to the
power source.
138
To Next Page
Loading...